2 Channel 5V DC / 240V AC Low-Level Solid State Relay snap-fit case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case with snap-fit lid for 2-channel 5V/240V Omron Low-Level Solid State Relay
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 63
- Makes
- 0
- Views
- 502
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Designed this tiny case with a snap-fit lid for a 2 -channel 5/240V Omron Low-Level Solid State Relay. It has been designed as a very fit, the SSR board and relay modules only just fitting inside. It is symmetrical with cutouts to access the terminals on either end, so you can mount the SSR in any orientation.
The board is mounted to the case by adding four heat set inserts and some tiny screws (see ‘required hardware’ below).
I am personally using this, mounted with some double-sided 3M VHB tape, inside a Rancilio Silvia espresso machine where it fits perfectly between the midframe and the water tank shield. I printed it in PETG, but I reckon any other non-flexible material is fine.
Required hardware:
- Heat set inserts: M3 x L3 x D4. Maximum length can be 3.5mm, this is just what I used.
- Screws: M3 x 4mm. You could probably get away with 5mm depending on the exact board thickness.
- Optionally, some double sided tape to mount it.
Printed this model? Show the community what it looks like by posting your make.
Like this model?