Solder Flux Paste Despenser
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I have looked around to try to find the best way to dispense Flux when soldering
- Rating
- 0 / 5
- Likes
- 89
- Downloads
- 179
- Makes
- 0
- Views
- 1,753
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This is my attempt to make a Solder Flux / Solder Paste Dispenser that is small, easy to print and easy to use. This is my attempt from all of my research various designs.
Note the Pivot point in the upper corner of the attached photo. The round disk requires a M5 brass insert to keep the rod in place while pulling the handle. You only need one but I show it outside to illustrate my point.
A M4 Cap head (25mm) joins a M4 nut to hold the handle to the holder ring
A M5 brass insert is placed in each of the two caps. One is for the top of the 125 ish mm rod and the other is for the bottom of the rod. I had to search for the proper rubber band but just double or triple up is you need to.
I printed at 75% fill, in ASA with supports. I don't think supports are all that necessary but the Tree supports comes off easy, so why not. Since the knobs are small, I used a raft because the first time, I got some spaghetti.