KLIPPT Anchor Spacing Jigs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Park those anchors at convenient 50mm spacing. Why 50mm? Well, look at some of my other models. You'll figure it out.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 26
- Makes
- 0
- Views
- 209
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
KLIPPT is really cool. It's a great way to clip a cable. But I'm a clumsy oaf and freehanding is stupid. Being a member of an obligate tool-using species and probably on my way to becoming an obligate 3D printing member of such, I designed up a parametric jig for spacing them out at 50mm intervals. Each of the jigs roughly corresponds to the small/medium/large KLIPPT clips in width, so you can weasel them into pretty tight spots.
- Note the first: load the clips into the jig wide bit down. They'll be tight. If they're too tight due to your printer's tolerances, download the f3d and mess with the I_xySlop variable. You also might want to try printing them in TPU; I haven't, but it sounds fun.
- Note the second: you'll need to torque down the screws more than you think, or it'll spin freely when you remove the jig. After drilling a pilot hole, my DeWalt DCD805B puts #6-3/4" screws in tight on setting 2.
Please note: all my Printables models that are not a remix of others' work are licensed CC-BY-NC-SA. Commercial usage is available upon request; please reach out via email.