Logitech C270 Camera Magnetic Mount (IKEA PLATSA) Screwless (pin mount)

Remix of the original to use plastic pin mounts in place of screws and make the base plate shorter so it only covers 2 holes in the Ikea Plasta enclosure. 

This design also uses rectangular magnets, with an additional overlapping frame around the pivot plate bracket to help the camera stay square/level. 

Printing

• Enclosure base mount (with pin mounts):
  • Material: I used Prusament Vanilla White PLA, but should also work well in PETG.
  • Print Settings (PrusaSlicer): 0.20mm Quality, 15% infill
  • Supports: None
  • Print Settings:
    • Vertical shells → Permimeters: 4 (to make pins solid)
    • Quality → Detect thin walls
• Camera pivot plate:
  • Material: I used Prusament Vanilla White PLA, but should also work well in PETG.
  • Print Settings (PrusaSlicer): 0.20mm Quality, 15% infill
  • Supports: None
  • Print Settings:
    • Quality → Detect bridging perimeters
• Logitech C270 webcam bracket:
  • Material: I used Prusament Vanilla White PLA, but should also work well in PETG.
  • Print Settings (PrusaSlicer): 0.20mm Quality, 15% infill
  • Supports: Everywhere as I couldn't find a good way to place this on the bed)

Hardware

• Logitech C270 720p Webcam
• 4 of 20x6x1.5mm thick Neodymium magents
  • Enclosure base mount, magnets are installed from the rear and kept in place by a small lip around the opening.
  • Camera pivot plate, magnets are installed in two pockets on either side of the mount.
• M3 20mm bolt and nut to secure webcam bracket to pivot base plate
• M3 30mm bolt and nut to replace original webcam base with the new mount.
  • To remove C270 original bracket, remove sticky rubber plugs and push the plastic securing pin out.