Ataman AP16 Pellet Gun Reflex Sight Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This part is designed to mount a Holosun 507K/407K reflex sight to an Ataman AP16 pellet gun.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 46
- Makes
- 0
- Views
- 1,239
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
This part is designed to mount a Holosun AP16 507K/407K reflex sight (or any sight using a modified shield mount) to an Ataman AP16 pellet gun.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.15
Infill:
50%
Filament:
NylonX Carbon Fiber
Notes:
Ensure filament is thoroughly dry to avoid corners lifting during the print. Holosun 507K uses a modified Standard Shield mount so any sights using this mount should work.
Post-Printing
Ensure top and bottom is flat
Lightly sand the top and bottom using a flat surface to knock off any high spots left during the print. Take care not to sand down the two registration bumps on the top.
Drill 2mm hole
There is a 2mm hole in the back left corner of the print that will need to be drilled to size to fit over the pin on the pistol frame.
Remove three screws holding the receiver cover on.
Leave the bolt tensioning screw.
Insert forward screw
The forward screw is tricky to install since it must be inserted at an angle and then rotated up.
Once the screw is vertical in its pocket, alight the rear pin and screw the part in place while gently pressing the rear down onto the pin.
Install remaining two screws
Once installed test the bolt operation. Over-torquing the screws can result in tight/sticky operation.
Mount the sight
Check both sides to ensure the part is sitting flush then attach the sight. Enjoy!
Category: Outdoor & Garden