1 / 1
FMS FCX-24 K5 Blazer Rear Window Cutting Guide — image 1

FMS FCX-24 K5 Blazer Rear Window Cutting Guide

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Use this guide for a clean cutout.

Rating
0 / 5
Likes
12
Downloads
56
Makes
0
Views
622
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Warning - the mounting holes/webbing inside the cutout are not perfectly centered. The window cutout is fine, and this just means that the inside guide will only fit in one orientation. It's such a non-issue that it wasn't worth fixing the model, but may confuse you at first.

 

To use :

1- Place the guide against the back wall of the cab. Hold firmly and drill 4 mounting holes.

2- Place the small guide inside the cab and secure both guides, with body shell sandwiched between, using M3 screws and nuts.

3- Drill out most of the material inside the hole.

4- Using a hobby saw or other tool, carefully cut the outside edges of the hole while following the guide closely.

5- Using a file or sandpaper, sand the edges of the cut down to meet the guide.

6- Remove guide pieces and cut remaining 2mm tabs.

7- Sand tabs flush with the rest of your cut.

8- Carefully paint edges of hole (or just use a sharpie like I did)

9- Clean up clingy styrene dust for the next 2 weeks.