Triple Dyson Accessory Wall Mounted Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A wall mounted holder that holds 3 Dyson vacuum cleaner accessories, compatible with Dyson V7 and newer
- Rating
- 4.889 / 5
- Likes
- 69
- Downloads
- 460
- Makes
- 5
- Views
- 2,354
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
A wall mount/holder for three Dyson cordless vacuum cleaner accessories, compatible with Dyson V7, V8, V10, and V11 (was only tested on V8, but the accessories for V7-V11 should be the same).
The mount has three 3.5mm (~9/64 inch) diameter holes for wall mounting screws, although using only two screws is probably sufficient. Do not over-tighten the mounting screws as doing so will crush the 3d printed part.
Supports are recommended for this print.
The two holders on the right were particularly designed to fit the mini motorized tool and the soft brush tool as seen in the cover picture, hence the angle and spacing. The left holder can fit the crevice tool, the combination tool, or any other narrow and straight tool.
Fusion 360 (.f3d) and STEP files have also been included for anyone to edit.
I also made another version this model to only have the two angled holders to fit on smaller print beds, which you can find here: https://www.prusaprinters.org/print/75857