Elegoo Carboard Rim / Ring for using Elegoo filament with AMS
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For using Elegoo filament on cardboard rolls in the Bambu Labs AMS system.
- Rating
- 4.333 / 5
- Likes
- 43
- Downloads
- 514
- Makes
- 3
- Views
- 2,154
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Made for Elegoo filament rolls.
The rings snap in on pairs of holes Elegoo has running around the edge of the roll. The images were printed in Prusament Galaxy PLA, because I had just a tiny bit left and they don't take a lot of filament. Note, the ‘clips’ are deliberately a little tight - they are designed to hook a tiny bit into the cardboard so they don't come off over multiple cycles.
There are four variants, because I have encountered multiple sizes of Elegoo rolls.
If you have a 0.4mm nozzle:
Try to start with the ElegooRing-199-5dia-0-85wall print. This fits most of my Elegoo rolls. If the 199.5 diameter print does not fit, then you can use the ElegooRing-200-2dia-0-85wall print. (Use Arachne perimiter generation, the rim should be 2 lines wide.)
If you have a 0.6mm nozzle:
Try to start with the ElegooRing-199-5dia-0-7wall print. This fits most of my Elegoo rolls. If the 199.5 diameter print does not fit, then you can use the ElegooRing-200-2dia-0-7wall print. (Use Arachne perimiter generation, the rim should be 1 line wide.)