Desk Stranding - IKEA Skadis mount

Hello everyone!

Project is created for mounting this awesome lamp to IKEA skadis pegboard.

It has a few shortcomings (mostly cuz I didn't want to go after the required parts) but It just works.

As I wanted to minimize the number of supports I divided the handle into two parts (p1 and p2) 

To stich them together u need 4x 15mm m3 bolts and 4x m3 nuts. Size of bolts is adjustable by leveling thickness of PART1 or PART2  (use thinkercad, fusion360 w/e, it's really easy) 

REMEBER! The thicker part at mounting section of PART1 must be mounted on the most heavily loaded side (usually the bottom) 

PART 3 (important!)

As I dont have long enough bolt to mount it to part1 I decided to use 2x m4 bolts and insert m4 nuts while printing. If u are in simillar situation, u need to use pause option, insert 2x m4 nuts inside and continue printing. If u have 35mm m3 bolt dont give a fuck, just Insert the screw and tighten the cap on the other side. 

Cables: 

Mount have hole for a cable. Try to guide it behind skadis for hiding it. Remeber to leave some slack for cable

Printing instructions:

Material: 

PETG or PLA with high infill density.

Layer height: 

Adjustable, im using 0.2 but u can use 0.15 or 0.3 as well. 

Supports:

Only for PART2

Infill:

Im recommending 100% for "legs" of part2 and mounting section of part1, but anything above 50% should be ok. 

for part3 use above 50% with triangle pattern.

Happy printing!