Simple STM32 Nucleo-64 Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A minimal, protective half-case for the STM32 Nucleo development boards, with heat set inserts and screws.
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 737
- Makes
- 7
- Views
- 2,675
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A little case for the ST Microelectronics Nucleo-64 Development Kit. Check the list below for compatible boards.
The board should sit quite firmly in the case itself and is held down by additional screws. The screw on the left side is really close to the pin headers, so a normal DIN 912 cylinder screw is too tight already. Leaving it out is fine though.
Recommended Material & Print Settings
Nearly every Material should work, Test prints were done in PLA.
No supports needed.
Two (or more) perimeters recommended for the screw pegs to be solid enough
Additional Hardware
2-3x M3x12 DIN 912 Cylinder Screws (between 10 and 14mm should be fine)
2-3x M3 Heat Set Inserts (CNC Kitchen ones tested, others may work as well)
Compatible Boards
NUCLEO-C071RB
NUCLEO-F411RE
NUCLEO-F446RE
NUCLEO-G0B1RE
NUCLEO-G070RB
NUCLEO-G474RE
NUCLEO-G491RE
NUCLEO-H503RB
NUCLEO-L073RZ
NUCLEO-L152RE
NUCLEO-L452RE
NUCLEO-L476RC
NUCLEO-L476RG
NUCLEO-U031R8
NUCLEO-U385RG-Q
NUCLEO-U545RE-Q
Probably many more. Let me know if you test others so I can add them to the list :)
Please consider liking the model and posting a Make :)