Gable Roof Peak Mount for Govee RGBIC LED Permanent Outdoor Lights H705A H705B H705C
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gives you a flat surface to mount a Govee light in the top center of a gable roof peak
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 240
- Makes
- 1
- Views
- 1,529
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This mount gives you a flat surface to mount a Govee light in the top center of a gable roof peak. I designed it to perfectly fit a roof with a pitch around 5.3/12 with the arctan(5.3/12) = 23.83 degrees. It should work fine for roofs with a similar pitch, or you can use FreeCAD to edit the design and match your own roof perfectly.
Plan ahead to hit the center and make sure the lights on either side are spaced evenly for a professional look. If hitting the center is too difficult and it's much easier to just have a light evenly spaced on either side of the peak then do that instead.
You can use screws up to imperial #8 (4.2 mm) to fasten the mount to your soffit.
Stick the light to the mount and install a screw clip on both sides of the light for a permanent installation. If you need more clips you can check out my design here on printables which was specifically designed for mass production of a large number of clips.
The FreeCAD .FCStd file is provided if you would like to change the dimensions or design of whatever you want. The step file is also provided if your slicer supports step files for better resolution.
My design is free for individuals to use for their own personal non-commercial usage. If you like my design and find it useful, a contribution made through Ko-fi or PayPal would be greatly appreciated!
Thanks for checking out my design and good luck on your project!
