1 / 1
DUMMY 13 - Belt, buckle and props V1.0 — image 1

DUMMY 13 - Belt, buckle and props V1.0

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A belt with different add-ons

Rating
4.75 / 5
Likes
140
Downloads
695
Makes
4
Views
3,215
Reviews
4

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

12. Feb. 2024 V1.0:

  • First release

Based on DUMMY 13:

DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0

Get your Dummy 13 here: /model/593185

Content:

  • Belt
  • Different buckles
  • Pocket
  • Ammo


 Get more:  /@Mici/collections

Printing:

  • Use PLA
  • Layer height 0.05 mm
  • The Belt:
    • Print it slow (~50%) without brim and use a glue stick
    • The quality of the first layer is crucial 

Assembly:

  • If you look at the inside of the belt, you will see a kind of groove.
  • This groove holds the belt in position above the waist
  • Pay attention to the orientation as shown in the picture
  • Start with edge 1 and slide it into the groove
  • Go counterclockwise and place the belt over the waist from position 1  to 4 (use gentle force)
  • Now put on the props and buckle that you like. You will probably need some glue
  • Make sure not accidentally stick the parts to the waist
  • To remove the belt, simply slide one edge on the back upwards

 

 

Tags