Flashing Pogo Jig - Ener-J Touch Switch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a very simple jig that uses pogo pins to locate the flahing points and secures to the circuit board connector.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 19
- Makes
- 0
- Views
- 396
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A solderless solution for those wanting to flash their Ener-J smart switches witha custom firmware to remove them from the cloud.
Additional parts needed:
5 x Pogo pins (I used pogo pins with a 1.01 outside shaft diameter)
Print with the flat surface to the print bed, no supports 1.5mm layer height.
The print is a tight fit to the onboard 8 pin connector, this is deliberate to hold it securely in place and ensure the pogo pins remain in contact with the solder pads without the need to be held.
Use tweezers to help insert the pop pins and ensure they are inserted so the outer shaft is flush with the housing.