1 / 11
Bungee hook for bike inner tubes
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
hook used to leverage old inner tubes to turn them into bungees
- Rating
- 5 / 5
- Likes
- 28
- Downloads
- 76
- Makes
- 2
- Views
- 475
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Notes
- rev 1 & 2 are sized for a 700 x 20-23 mm tube
- rev 3 is sized for a tube that is about 47 mm flat, probably a 26 x 1.5" tube
- Parts below printed in Tough 2000 on a Form 3
- as of 2024-02-18, both rev 1 & 2 do experience some slippage under tension
- rev 3 will try to tighten this up substantially
Rev 1: hook in plane with adjustment
To be used like so:
Optimized for FDM printing this way, but inconvenient to use the hook because it'll stick out as shown above.
Rev 2
Hook faces perpendicular to the plane of the buckle, & I tightened up the fit of the buckle around the tubes.
Rev 3
- rev 3 is sized for a tube that is about 47 mm flat, probably a 26 x 1.5" tube
- much tighter, satisfactory fit
