Parts for an Easy Weaver Rigid Heddle Loom from Friendly Loom
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement parts for an Easy Weaver Rigid Heddle Loom from Friendly Loom
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 22
- Makes
- 0
- Views
- 335
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I picked up an older model Easy Weaver loom at a second hand shop, but it was missing quite a few pieces, including a shuttle. They are generally made out of a wood species such as beech, which is hard to find around here. In addition, other woods hard enough would cost me more than I paid for the loom. I have also found that replacement parts online are generally cheap and poorly made. This is where the 3d printer comes in.
The Easy Weaver Loom has four supports screwed onto a plywood board. The holes for the screws seem to have been placed using a pattern for each individual hole. This means that they do not appear perfectly placed. It's just that the pattern would have been rotated 90 degrees. So, for instance, one hole may be 10.5mm from the first edge and 8.5mm from the second, while the hole above it is 8.5mm from the first edge and 10.5mm from the second. Get it?
On each 25mm (1 inch) thick dowel is a gear held on by two pins, and a pawl used to brake.
Here you'll a model for each of the four supports, one model for the two identical gears, one model for the two identical pawls, and one model for the four identical feet (not pictured).
The model I have is the older model with no shedmaker (or even a hole for one) and the heddle doesn't have a clip for a shedmaker, unlike the newer models. However, there is an in-between model that shows how these pieces go together. The manual is here. Eventually I'll make a clip for my heddle and a special “shedmaker” for each side that holds the heddle in one of two positions.
Except for the gear, they should all be easily printable at most layer heights and nozzle sizes, with 25% infill. The gear should get a 0.4mm or 0.2mm nozzle with standard layer heights and 100% infill.
For more loom models, visit my Loom collection on Printables.com.