Parametric friction fit conical lens hood
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple parametric lens hood for older cameras, especially those which focus by rotating the front element of the lens.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 63
- Makes
- 0
- Views
- 313
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Share Alike
Hello :)
This is a little parametric Openscad file for making a conical lens hood which fits with friction. It should be especially useful for cameras with rotating front element (yes the Rolleicord in the picture is not a good example for this).
I was pretty conservative with the calculations and I used it myself so it shouldn't cause any vignetting.
There are STL files for a Rolleicord II, first version Triotar 3.5 lens and an Ikoflex II/III Tessar lens. You can also check out my account for lens caps for these models with a parametric file for making your own custom TLR lens cap. The Rolleicord hood has an added notch because there is a small metal part that would block it otherwise.
I am not a programmer nor a designer so the design and code might be a bit rough, sorry. Feel free to ask questions or to improve it.
It prints without support (except if you make a very wide hood), use black material and no special slicer settings should be necessary.