AM23
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A fully automatic nerf blaster.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 25
- Makes
- 0
- Views
- 346
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial
Introduction:
The AM23 is an attempt to make a simplistic fully automatic blaster.
There were a few goals of the project, which are as follows:
1: Create a simple-to-build blaster that used common blaster parts
2: Make the blaster loosely resemble the Kalashnikov pattern rifles
3: Make the blaster cheap to produce
Building Notes:
The micro-switches that the blaster uses for its electronics are to be glued in
place (With exception of the return switch which friction fits). All of the screws are to
be manually tapped into the plastic, this decision was made in order to make the blaster
cheaper to produce and to make it easier for people to source parts. There are a variety of flywheel and motor combinations that this blaster can accept and the battery tray in the stock can handle up to a 5.2Ah 3s lipo battery. The performance can vary depending on the builder's choice of parts, expect performance from 120-150 fps. The rate of fire is determined by the builder's choice of n20 motor.
Hardware Required:
4-40 Screws
21A Micro-Switch (x2)
10A Micro-Switch (x1)
2mm Elastic Cord
18 Guage Wire (5ft)
130 Size Motors (x2)
N20 Gear Motor (x1) (MAX RECOMMENDED RPM IS 1000!)
XT60 Male Connector (x1)
Contacts:
Email: [email protected]