1 / 3
Hazard 4 HardPoint compatible mount - M3
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounting point for Hazard 4 HardPoint® mounts on backpacks and bags.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 24
- Makes
- 0
- Views
- 241
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Fully compatible with original HardPoint® Gear Rails and Beavertail attachements.
Print with 50%+ infill, PETG or Nylon recomended.
Designed for M3 x 10~16 screws and M3 x 4.5 x 5 brass inserts with 2.9mm neck.
If printed in PETG, you could insert them without heating, just using a vice and some washers to push it flat with back surface.
Also, you need some kind of hex driver for weekly tightening screws, since PETG will deform under load, and after 2-3 times you can apply soft thread locker to prevent it from unscrewing.