1 / 3
🐶💩 Outdoor Dog Poop Bag Dispenser — image 1
1 / 3

🐶💩 Outdoor Dog Poop Bag Dispenser

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Holds AmazonBasics and various other dog waste bags. Designed for mounting outdoors. Water resistant and quick drying.

Rating
5 / 5
Likes
122
Downloads
716
Makes
17
Views
3,095
Reviews
18

Updated at source:

Model information

Category
Pets
License
BSD License

Specs

Holds bag rolls up to 35mm diameter, 65mm wide.

  • ✅ AmazonBasics
  • ✅ Frisco
  • … and many others!

Print tips

  1. 🧩 2 parts: Main body and “pin”. Print separately for cleanest finish.
  2. ⮑ Print body left side down. Print pin upside down.
  3. ✨ Support free!
  4. 🏋️ 15% infill
  5. ☀️ Use PETG or ASA filament for UV resistance if exposed to direct sunlight.
  6. 🧵 Set “Seam Position: Aligned” for the main body in PrusaSlicer (included in the pre-generated gcode) in order to minimize surface burrs inside the dispenser.
  7. ⚓️ Try a raft for the “pin” if you have issues with bed adhesion
  8. 🔥 DRY YOUR PETG! It will make a smoother surface finish.

Quality Assurance!

While the inside of the dispenser was designed with rounded edges, the printer can still produce rough surface artifacts. Although your prints will be nice and smooth with the above recommendations (dry filament + seam position), it's best to check.

  1. 👇 Run your finger over the inside of the print. Clean up any burrs with sand paper.
  2. 💡 Run a bag through the dispenser, hold it up to the light, ensure no damage.
  3. 📍 Initially, the pin might be a tight fit. Run it through a couple dozen times and it'll get noticeably looser.

How to mount

  1. 〰️ Zip Ties - perfect for a chain link fence, or for quick/semi-permanent install.
  2. 🔩 #8 wood screws (or smaller)
  3. ✂️ Double sided mounting tape (not recommended)

Tags