EIBOS Artemis E3D Toolchanger Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Direct Drive E3D Toolchanger mount for the EIBOS Artemis Extruder
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 125
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is the mount I created for the E3D Toolchanger and EIBOS Artemis Extruder in a direct drive config. Currently this would work for To & T1 without other modification to the existing printed parts.
This replaces the V6 Receiver Top and uses the same hardware to hold the mount down, you then use 4 M3 10mm bolts to hold the Artemis to the mount. The wire strain relief mounts to the side with the M3 set screw.
I created this mount with the used of models from both kswaid (Thingiverse) E3D (Printables), so thank you too both sources.
Print settings:
.2mm layer height
3 walls
40% Infill
I used PLA filament
Prints without supports