Pulsator Core Gear Sleeve Connector for LG Automatic Washing Machine - Repair Part
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An experimental replacement part.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 82
- Makes
- 0
- Views
- 939
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Public Domain
EDIT (Mar. 6, 2024) : Since I first posted this print, I have received a new replacement part. Using the new part, I was able to get better measurements, so I have posted a V3 STL using the new measurements (but I have not printed this part). I have also uploaded pictures of the new part next to the old part.
Although my V2 version was not completely accurate, it still fit the washer, and has now held up for 10 wash cycles.
EDIT (Mar. 11, 2024) : The plastic part failed on the 11th wash cycle. It was a good temporary fix, but no good for long term use. I removed the plastic part by screwing in a ½" bolt, and tapping out the bolt from the top side.
END EDIT
This is an experimental print; it is not known how this will hold up to regular use. I made this print as an experimental replacement, until such time as I could receive a metal replacement part.
Be aware there are different spline fitting for different LG washer models. This particular spline fitting has 15 outside teeth and 11 inside teeth.
Read below for more details.
Does your LG top loading washer have this symptom? : The wash tub will rotate, but the "pulsator plate" does not move, or has become disconnected entirely. If so, this print may be useful to you.
Note: See this video for instructions on removing the pulsator assembly.:
Many top-loading models of LG brand washers use a “pulsator plate” (also known as an agitator plate). This large circular plate (see photos) oscillates back and forth during the wash cycle, and is attached to a drive shaft with a spline fitting at the center of the plate. Unfortunately, the high torque on the spline fitting (made of cast metal - probably Zamak) eventually wears down the internal spline teeth.
One solution to this problem is to replace the entire pulsator assembly, but it is also possible to purchase just the spline fitting for considerably less.
Assembly and Use
Remove the pulsator assembly as shown in the video. Note that on the top center of the plate there are three small semi-circular slots. By putting a small screwdriver into these slots and tapping with a hammer, it is possible to remove the metal spline fitting (I recommend tapping all three slots alternately). The spline fitting is wedged in tightly, so it will take some good solid hits to tap it out.
With the metal spline fitting removed, place the 3D printed part in the opening and pound it in using a wooden block and a hammer. The replace the pulsator assembly as shown in the video.
Does it Work?
I order a metal replacement spline fitting, but while waiting for the part to arrive I thought it would be interesting to see if a 3D printed part would work. The short answer is yes.
However, as of this writing (Feb. 29, 2024) I have only run the washer through two wash cycles, so I have no idea how long the part will hold up in regular use. I plan to use the 3D printed part until it fails; I will update this posting after further use (or part failure).
Print Instructions
Print in PETG using the 3mf files provided, otherwise :
- 0.2mm layer height
- 6 perimeters
- 25% rectilinear infill
Note that the top hole of the spline fitting has sacrificial fill for print purposes - simply remove this with a razor knife.
CAD
The OnShape 3D CAD files for this are here :