Hey, That's My Fish Board Game Accessory
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.56 – €4.35 net (excluding VAT)
For file: puzzled-board-2.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.95 excluding VAT (range midpoint).
- Weight reported by the author
- 42 g
- Print time reported by the author
- 4.31 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a board to hold the pieces for the board game Hey, That's My Fish.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 202
- Makes
- 3
- Views
- 1,456
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution — Share Alike
This is a board to hold the pieces for the board game Hey, That's My Fish. It's a fun game and good for kids, but it lacks a piece to hold the pieces in formation. That's where this board comes in. There are three main differentiating features:
- There's an inset raised hexagon inside each cell so you can press on the side of a tile and it'll flip upwards for easy removal. Even a 3 year old can do it.
- The board is divided into four interlocking puzzle pieces so it can be printed on most 3D printers. The board in its entirety is just a bit too large for a Prusa MK3S.
- The full board is generated in OpenSCAD, so it could be useful for other games too.
I've included the full board as well as the cut up board along with the OpenSCAD file that was used to generate the full board.
If you don't already own the board game, consider purchasing it through my referral link: https://amzn.to/2WrJ9sB There is no additional cost to use it. Thanks.
Print instructions
I would recommend printing with the flat sheet as opposed to the textured sheet for bed adhesion purposes. It is untested with the textured sheet, but I'd guess it would warp a bit making it hard to put together.
With my printer and the gcode I included there isn't any visible warping: the bottoms are flat.