VM-1 Phone Stand (Vase Mode!)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.66 – €0.81 net (excluding VAT)
For file: Phone_Stand_VM-1_N4Plus.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.73 excluding VAT (range midpoint).
- Weight reported by the author
- 14 g
- Print time reported by the author
- 30 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A phone stand, but printed in vase mode!
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 55
- Makes
- 0
- Views
- 595
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
And we've stepped it up a notch today, folks. The VM-1 phone stand awaits—if you download the file below, slice it, and send it to your printer. Okay, okay, I get it. Why would you want to print a vase mode phone stand, when a single layer wall clearly isn't going to be enough to hold your phone? Well, let's just change that to say that it is enough to hold up your phone, especially using the correct print settings. After multiple iterations, I have finally come up with what I believe to be a sturdy vase mode phone stand, that doesn't block your view of the screen, and looks good to boot. Oh, and it's definitely a quick print even at slower speeds. At 200mm/s, I'm getting just shy of 30 minutes.
Now, being that it's a vase mode phone stand…
Minimum printing requirements for a strong stand (Please be sure to check these!):
- Nozzle: 0.40mm (see note below)
- Layer height: 0.20mm or smaller.
- Line thickness/Extrusion width: 0.60mm (see note below)
- Mode: Spiral vase, smooth spiral, spiralize outer contour. Different names for each slicer, but whatever gives you a continuous spiral with one wall is the one you want.
- Bottom shell layers/Bottom thickness: 0, zero, zip, nada, nula (as in, please turn off your bottom shell if you want it open on both sides)
- Print orientation: On its side as oriented in the STL file
Note: Larger nozzles can lead to stronger prints in vase mode. Therefore, if you have a 0.6mm or larger nozzle, don't think you can't print this. A general rule is that you can set your line thickness to be 150% of your nozzle size. A 0.40mm nozzle can print well up to 0.60mm line thickness. A 0.6mm nozzle can print up to 0.9mm line thickness. And on and on. At some point it will be diminishing returns, but if you already have a larger nozzle on there, increase your line thickness and go for it!