Creality CR-10 Smart Bondtech LGX direct drive mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This model allows you to mount a Bondtech LGX in a direct drive configuration on your Creality CR-10 Smart. This mount…
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 114
- Makes
- 0
- Views
- 1,938
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This model allows you to mount a Bondtech LGX in a direct drive configuration on your Creality CR-10 Smart. This mount allows the strain gauge still to bend and allow leveling.
Step file and Fusion 360 archive included. Please adhere to the license and attribute.
Bill of materials
- One Bondtech LGX with either the direct drive or bowden interface plug attached
- 2x M3x14 screws
2x M3x10 screws If using a reverse bowden mount to feed filament (recommended):
A PC2 bowden coupler
2x M3x10 screws Update 2021-09-21: I found some reliability issues with the rev1 design. Updated
Print Settings
Printer:
Creality CR-6 SE
Rafts:
No
Yes
Resolution:
0.2mm
50
Filament: BIQU Matte PLA Olive green
Notes:
You need a little bit of support for the part that screws into the X-carriage.
Assembly steps
Note: Prefer to use the direct drive interface plug.
1. Mount the LGX to the mount.- Remove the interface plug from the LGX. You need this later to cut the bowden tube to length.
- Push the mount onto the spacers of the wheels. It should snap right into place.
- Use the existing bolt to fixate the mount.
- Cut a bowden tube to length and stick it into the hotend. Leave about 2mm play so the strain gauge can push the bowden tube into the LGX a bit while leveling and homing. If you use the Bowden interface plug instead, you need to cut your bowden tube in half instead.
- Print and mount the reverse bowden interface, or find a solution for the filament sensor and spool location. Note: The LGX is allowed to run at 1A current maximum. You either need to decrease the vref on the stock motherboard, or install a BTT SKR CR6 motherboard
Category: 3D Printer Extruders