1 / 4
Breville Barista Express/Pro Single Dose Hopper - Vase mode! Magnetic!
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed for a more refined look, smooth interior with vase mode and magnetic cap!
- Rating
- 5 / 5
- Likes
- 35
- Downloads
- 167
- Makes
- 3
- Views
- 1,533
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Remixed from the original model by Simbungu: https://www.printables.com/model/80817-breville-barista-express-single-dose
- Refined look
- Added magnetic cap!
- Cap can be used to measure the beans!
- Feeder is separated as inside and outside to have continuous internal surface
- Vase mode shell that can be inserted inside the feeder for seamless internal!
- Vase mode shell for cap!
How to print:
I printed everything in PLA on Bambu p1p with 0.4 nozzle. I didn't scale anything while printing, however shells can be slightly scaled or flow can be adjusted to make them fit perfectly
Magnets are 4mm round and 2mm thickness. Total 24
- Feeder inside: 3 walls, 15% infill, 0.5mm wall thickness, 0.2mm layer height
- If you are planning to add magnet, pause at appropriate layer and superglue the magnets to avoid them sticking to nozzle
- Feeder locking mechanism: 2 walls, 15% infill, 0.5mm wall thickness, 0.2mm layer height
- Cap: 2 walls, 15% infill, 0.5mm wall thickness, 0.2mm layer height. Option to print magnetic or non magnetic version
- If you are planning to add magnet, pause at appropriate layer and superglue the magnets to avoid them sticking to nozzle
- Non magnetic cap has two versions. Both can be scaled to adjust the fit
- Feeder inside shell: Print with 0.6mm wall thickness, 0.2mm layer height, 0 bottom layers. I printed at 100% scale and it fit perfectly. If it doesn't fit well, adjust the flow or scaling
- Cap shell: Print magnetic or non magnetic version based on what cap you print. Use 0.6mm wall thickness, 0.2mm layer height, 3 bottom layers so that the thickness at the bottom is correct. I had to scale height by 0.4mm for proper fit.
- Hopper Base: 2 walls, 15% infill, 0.5mm wall thickness, 0.2mm layer height
Assembly:
- Print the pins as in the original model mentioned above
- Sand the seam on the inside of the feeder so that feeder shell fits perfectly
- Use a small amount of superglue to glue the shell
- Glue the Feeder locking mechanism
- If you print the cap shell, the fit would be tight enough because of vertical wall and glue is not necessary. Grind the outside seam and the elephant foot of the cap before fitting
- Assemble the rest as per instructions in the original model