1 / 5
Hinged Lid mod for FixDry Double Filament Dryer Drybox
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cut the FixDry lid in half and add a Hinge and Surround to make it easier to load filament spools.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 24
- Makes
- 0
- Views
- 455
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Cut the FixDry lid in half and add a Hinge to make it easier to load filament spools. Reaching the filament holes is easy when the lid is separated.
Two surround options are included to make the top half seal to the bottom half - one for a hinge and one without the hinge cut.
Directions:
- Mark a cut line 80mm from bottom edge.
- Drill holes for the hinge first.
- Cut the lid along the cut line with a Table Saw
- Install Hinge and Hinge Stop. Make note of the screw pattern from the picture because it's not symmetrical.
- Glue the Surround to the edge of the lid. The surround takes into account that the saw will remove 3.8mm of material.
- The Full Surround can go on the lower lid if used without a hinge or the Surround w Cut can go on the upper lid so it won't interfere with the case feeder and because it has a handle.
- Cut slots for the Filament Outlet.
This Hinge was used, scaled 150% Print in Place Hinge – PETG/ASA – Low Strength 150 - LR Basics by Lucky Resistor | Download free STL model | Printables.com