Mk 4 new bits
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.26 – €0.32 net (excluding VAT)
For file: YmotorSpacer 1+2MM_MK4_0.3mm_PLA_MK3S_16m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.29 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 16.2 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
1) a spacer for the Y motor 2) a strain relief for the X motor cable
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 33
- Makes
- 1
- Views
- 412
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to shift the y motor pulley a little more that the shaft would allow. this shim did the trick (I had to use longer screws, however.
Also, I felt the X motor wire looked a bit exposed and prone to flexure at the motor housing. this simple brace is a pressure fit around the housing and the cable