iPhone and Apple watch charging stand - for magnetic chargers - use with new Standby mode

This stand was designed with the following goals:

• Fit up to largest iPhone horizontally (for new standby mode) or vertically
• Fit up to largest Apple Watch (with ledge that holds heavier ones)
• Hollowed rear sections to help heat dissipation
• Cable tidy through and around back
• Wide stable base
• Print in place without supports
• Curvy / smooth design

It was designed using aftermarket magnetic chargers:

• iPhone - Diameter 56mm, such as: https://www.aliexpress.com/item/1005006192667759.html
• Apple Watch - Diameter 28.5mm, such as: https://www.aliexpress.com/item/1005006255435075.html

Print Settings

This model prints without supports, standing upright (flat on its base).

To assemble

Fit the Watch charger first:

* Bring cable from front of charger and through Watch charger hole * Slot the USB plug through the cutout at bottom of stand (behind Watch tower) * Guide the cable through the cable tidy under Watch charger, then underneath (around) the stand * Gently (using a flat head screw driver for example), push the cable sideways along the cable tidy, so it is held in place by the specially designed (hidden grove) * Guide cable through rear stand cable exit slot * Gently move cable along to sit in the leftmost groove (to hold it in place)

Fit the Mobile charger next:

• Bring cable from front of charger and through Mobile charger hole
• Slot the USB plug through the cutout at bottom of stand (behind Mobile tower)
• Guide the cable through the cable tidy behind Mobile charger tower
• Gently (using a flat head screw driver for example), push the cable sideways along the cable tidy, so it is held in place by the specially designed (hidden grove)
• Guide cable through rear stand cable exit slot
• Gently move cable along to sit in the middle groove (to hold it in place)