Sapphire Plus/Pro Mosquito Smasher (Mosquito Mount)

Before all thanks belongs to EnDva3D,

His/Her design was good but have a few problem for my machine; such as 5015 cooler fan touching stepper motor and top rail, also if you left a space on z rods for z banding compansation; fan mount smashed to them when bed leveling or printing big objects so I edited (shaved) cooler fan mount and made it horizontal so its free from any obstacle(also free from sucking FOD's), lastly I redesign the main body to put bltouch to backside(New coordinats X=0 Y=29, and I assure you its not getting hot)

-You might need to impale a hole from inside of the 5015 fan shroud for one screw

-Both 4020 and 4010 fan supports included feel free to use any of them
for 4010 print 1,2,3,4
for 4020 print 1,2,3,5

-Before I forget, also make sure you do pid tuning when blower is %100 and when I do water test for blower, there was too much air flow so some would like it but to me it is a lot and I tuned down %25 for my usual prints

hope you will like it!!!

Print Settings

Printer:

TwoTrees / Sapphire Plus

Rafts:

Supports:

Yes

Resolution:

Infill:

25

Filament: Porima PETG Yellow/Deepblue

Notes:

Category: 3D Printing