1 / 16
Tronxy X5S Marlin 1.1.9 — image 1
1 / 16

Tronxy X5S Marlin 1.1.9

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The original display works, selection knob runs smoothly (menu down clockwise, enable REVERSE_MENU_DIRECTION if you'll…

Rating
0 / 5
Likes
1
Downloads
7
Makes
0
Views
259
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

The original display works, selection knob runs smoothly (menu down clockwise, enable REVERSE_MENU_DIRECTION if you'll want the original feel).

AutoTemp disabled but Filament Change is enabled (under the Tune menu)

The Filament Change procedure Configuration_adv.h:

PAUSE_PARK_RETRACT_LENGTH 6 // 2(mm) Initial retract.
avoid the blob

FILAMENT_CHANGE_UNLOAD_LENGTH 850
The filament should stop a few cm before exiting the feeder. The value depends on the length of the tube

FILAMENT_CHANGE_FAST_LOAD_LENGTH 800
The new filament is fed quickly near the nozzle, see above

ADVANCED_PAUSE_PURGE_FEEDRATE 3
The remaining fed is done slowly to clean nozzle.

ADVANCED_PAUSE_PURGE_LENGTH 100

If the extrude won't come clean increase the value. (Press the button to proceed printing quicker)

NOTE: Compile with Arduino 1.8.5 !!
Sketch uses 129196 bytes (99%) of program storage space. Maximum is 130048 bytes.

(Arduino 1.8.7 compiling consumes 130064 bytes and there for doesn't fit in)

Category: 3D Printers

Tags