Ipad reverser for K&M holder/music stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Do you have a K&M music stand for your ipad pro, and have you been annoyed that your ipad must be inserted upside down…
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 37
- Makes
- 0
- Views
- 1,290
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Share Alike
Do you have a K&M music stand for your ipad pro, and have you been annoyed that your ipad must be inserted upside down for your pencil to fit on the side of your ipad? Well, your frustration is over, with this ipad-reverser!
As an added bonus, you get to pick a nice colour for one part of your stand. Or just keep it black.
Just download, print at a layer height of maximum 0.2mm. No supports needed, but pick a filament and settings that do bridging well without too much sagging.
Then disassemble the holder of your stand. Use the big screw to push through the hole that's closed at the bottom of the printed part - it's there so you don't need to use supports. It is only a single 0.2mm layer thick, so this should be easy to do.
reassemble the ipad holder with your printed part, and you're done! If this isn't clear, see the photos below for further instructions.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
No
Supports:
No
Category: Music