1 / 5
AnyCubic i3s XL Reel Holder — image 1
1 / 5

AnyCubic i3s XL Reel Holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A replacement for the metal reel holder that can hold up to a 2.2 Kg reel. Indents should also keep a 750 g and 1 Kg.

Rating
0 / 5
Likes
0
Downloads
7
Makes
0
Views
177
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

A replacement for the metal reel holder that can hold up to a 2.2 Kg reel. Indents should also keep a 750 g and 1 Kg reel in a steady position while printing. Its a slot in replacement for the metal reel holder supplied. You can use two M3*20 bolts to secure it (I did), but I suspect it would be fine without the bolts.

Print Settings

Resolution: 0.2mm

Infill: 25%
Filament: ColorFabb PLA 
 

Notes: 

Given the weight of the large reels I chose a high infill.

Post-Printing

Install

Remove the two bolts holding the metal reel holder in place. Place the slot in the larger end of the reel holder over the metal arm attached to the printer and push it down until the holes align with the bolt holes in the metal arm. I used 2x M3*20 bolts and M3 nuts to secure it - fitting the nuts into the small slots in the underside of the reel holder. (Honestly, it's probably overkill, and it would be 100% secure without the bolts)

Category: 3D Printer Parts

Tags