1 / 1
Cable chain ends for Igus E2i-10 -- Two hole
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Male and female chain ends for Igus E2i-10-10-018-0 cable chains with two mounting holes.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 53
- Makes
- 0
- Views
- 281
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Cable chain ends with 2 mounting holes to allow mounting directly to an extrusion for example.
Note that these do not have the strain reliefs that the genuine Igus ends have. All wires should be secured at both ends of a cable chain with enough slack for the wires to go down the center of the cable chain.
Printed in PETG with .2 mm layer height, no supports. For use in an enclosure a higher temperature filament would be preferred, such as HT PETG or ABS. I'm just using these for a mock up.