1 / 4
Dowel end cap for backpag/bag internal structure frame stays
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These caps allow a simple way to securely stitch in structural dowels and add internal frame stays/supports to any bag.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 16
- Makes
- 0
- Views
- 312
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
There are 2 sharp edges along the inside of the tube to ‘gouge’ the wooden dowel and hold it securely; just push down with the print against the floor to seat the dowel end.
The model is meant for a ½" (13mm) dowel, but can be trivially sized for any diameter.
The thread holes (I am using waxed cotton cord) are 3.2mm, and so should size down easily with room to spare.
I printed with no supports, and just let it bridge the surface at the top of the cylinder (doesn't have to be too clean anyway).