Paper towel adapter for Kruger Titan Bold dispenser + onshape link
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for that stupid round piece that gets stuffed into the paper towel tube in this poorly designed dispenser.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 54
- Makes
- 0
- Views
- 357
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
The piece gets plugged into the tube and then into the plastic arm in the dispenser. It fit tight enough to not spin in the arm but the tube spins over the printed piece. I thought I gave it enough clearance so I may have way overcompensated for ABS shrinkage.
It prints without supports if the end that goes in the roll is set as the base or the orientation that most resembles a lego piece. I did like 3 walls and 20% infill in ABS and probably less would work. Go with what your heart tells you for your particular plastic.
Here is the onshape link to correct my potential mistake before printing or adapting to a different tube size, or dispenser size with the same lousy design:
Just double click the sketches on the side panel and change the diameters of the circles to make it fit other sizes. The fillets should make it able to print without support and still be possible to remove if you make it snug in the roll end.
Like my other onshape part I just copied what other onshape users set their license to. Please inform me if I should change it for any reason.