1 / 10
Monoprice Ultimate/Wanhao D6 Filament Spool Holder with Bearings — image 1
1 / 10

Monoprice Ultimate/Wanhao D6 Filament Spool Holder with Bearings

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is yet another filament spool holder for the Wanhao D6 with bearings. This will hold standard 1KG spools and 3.5…

Rating
0 / 5
Likes
5
Downloads
42
Makes
0
Views
517
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This is yet another filament spool holder for the Wanhao D6 with bearings. This will hold standard 1KG spools and 3.5 KG spools that measure 12" x 4". The designs I tried didn't work with my cheap 608 bearings as putting pressure from only one side would lock them up. The spacer tube in the middle and the two small washers prevent this in the new design. The large tube only makes contact on the outside of the bearings so all can move smoothly. Used a 12 cm M8 screw (or 5/16, 4.5 inch), washer and nut I had around to hold this together. Use the original holder nut that came with the printer to attach.
Finally made this as I realized that all the spools I run through this where cutting into my fixed holder and particularly Ninjaflex was getting stretched quite a bit by the extruder.

Empiricus@Dremomys

Print Settings

Printer Brand:

Wanhao

Printer:

Duplicator 6

Rafts:

No

Supports:

No

Resolution:

0.150 mm

Infill:

30

Notes:

Printed this in ABS., Ad brims if you have problems with the tubes adhering to the bed.

Category: 3D Printer Parts

Tags