Printrbot Simple Open Air stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is derived from my other enclosure where I decided to eliminate all the enclosure parts so I could install the…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 145
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
This is derived from my other enclosure where I decided to eliminate all the enclosure parts so I could install the new 10" X-Axis upgrade without making this giant table box enclosure. So I went with an open air design that can still hold a full size power supply, LCD control panel. SD card extender, cooling fan, spool holder, USB panel plate and there is still room for a Raspberry Pi. The whole box is as short as it can be because of the LCD and power supply then the Printrbot is recessed into it as low as possible while still allowing the bed to clear the sides. Even with the printrbot lowered there is still 2" of open air under the whole unit to allow for the cooling fan to keep the electronics nice and cool. IT also stabilizes the whole printer. If you don't have access to a laser cutter let me know and we can work something out. Be sure to check out my other enclosure if you don't plan on getting the extended bed. http://www.thingiverse.com/thing:828774
Category: 3D Printer Accessories