Wandring Fenster Ring Osterhasen zum hinhängen
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.47 – €1.80 net (excluding VAT)
For file: Osterhase_Ring+1mm_0.2mm_PLA_MK3S_1h43m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.64 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 1.71 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Ein schöner kleiner Ring mit zwei Osterhasen
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 167
- Makes
- 0
- Views
- 476
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
Ich habe hier einen schönen Wand Ring bzw. Fenster Ring mit zwei Osterhasen Konstruiert.
Das Modell wurde in PLA gedruckt. Falls der Ring in ein Fenster gehängt werden sollte, würde ich ihn evtl. in PETG wenn nicht sogar in ABS/ASA drucken. Einfach weil es sein kann das der Ring sonst ein Ei wird. OK, dann schaut es mehr nach Ostern aus, hätte auch was.
Am besten Diagonal Drucken damit der Druck auch auf Druckbetten bis 210mm passt
Durchmesser: 210mm ohne die Öse oben (inkl. Befestigungsöse, Höchster Punkt ca. 220mm)
Höhe 5mm des Ringes