1 / 3
Peak Design Mobile and MagSafe Mount for TwelveSouth Hoverbar
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple print to adapt any MagSafe-compatible phone to TwelveSouth's Hoverbar stand.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 35
- Makes
- 0
- Views
- 559
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution
A simple print to adapt any MagSafe-compatible phone to TwelveSouth's HoverBar stand. When printed with their raised SlimLink boss design, there's a bit of extra security when pairing this with a Peak Design Mobile Everyday Case.
Incorporates four cylindrical refrigerator magnets (10x3mm).
Tips:
- Print this on the phone side face. 0.15 mm layer height recommended.
- If printing with the SlimLink boss, use supports.
- If printing without SlimLink boss, no supports are necessary.
- Configure a pause in your slicer at the last layer before the magnet holes are bridged over. Insert the four 10x3mm magnets taking care to orient the polarity correctly (use your phone or phone case to test, then transfer appropriately into the print).