Modern Planter

Modern Planter

A modern and hygge planter with cozy feet for all potted plants, e.g. succulents and other greenery. With a hole so that excess water can drain away and be collected in a small water reservoir in the lower part. Match the print with your favorite colors to your interior style. Easy to print and beautiful to look at.

Sizes

Each individual folder contains all the files required for printing. Just don't mix them up.

It is best to measure your plant beforehand to determine the correct diameter. If you need other, individual sizes, please write to me in the comments and I will upload the right size!

Print Instructions
 

• Top
  • Print in Vase Mode
  • I just used default PrusaSlicer Settings with 4 Bottom layers
  • If you need a custom height, just use the 'high' Model and cut it to size in the slicer
• Bottom
  • Print it upside-down
    • for large diameters, use support for the inner part (the small pin holes do not need support)
  • I like it printed with fuzzy skin (Settings: 0,15mm thickness, 0,8mm point distance)
• Stand
  • Print it upside-down
  • no support needed
• Pin
  • Print it upside-down
  • you need 3 pins

Filament

I prefer matt PLA filament, e.g. extrudr nx2. But of course that's just a personal preference :)

Assembling

First, push the three pins through the holes in the upper part from the inside. Tip: use pliers or tweezers to help with small diameters.

Then carefully and loosely insert the pins into the holes provided in the lower part. When all the pins are in place, press firmly to secure them. Simply position the feet into the base from below, using a few drops of superglue or plastic glue if necessary.