5 inch - 12 cm - Fishing plug with glow stick and adjustable action heads
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
5 inch Salmon fishing plug - with adjustable action
- Rating
- 5 / 5
- Likes
- 28
- Downloads
- 202
- Makes
- 0
- Views
- 1,333
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
April 17, 2024 _ Update - added a second .3mf containing head models intended to print and use stick-on eyes.
This is a model in multiple parts for a fishing plug. I used to make these and sell them and they were quite popular, but the multi-part design made the labor involved in making them more than I could afford to ramp up quantities.
Features -
interchangeable heads - if you like to go fast or go slow, you can change the action of the lure by using either the 30 or 45 degree drag angle heads. The 30 degree head gives good action up to 3.5 knots speed. The 45 degree head has less action at lower speeds and gives good action between 4 and 5 knots of relative speed through the water.
glow stick fits inside - heads have a receptacle that puts a glow stick inside the lure - use a clear filament and you get glow in the dark. Use clear filament on the eye parts and get glow in the dark eyes.
rigging- the head channel fits a standard 6 bead swivel chain (sold separately!)
Printing - Experiment with supports - the body is shaped to not need supports when it prints. The head prints well with snug supports everywhere. This will fill the eye channel and glow stick hole with supports - and you will need standard sized drill bits to clear the channels.
Finishing
The eye parts are a tube that fits through the head and then the small pips get tapped into place after the eye tubes are driven through the head. The tolerances are designed for standard American drill sizes - so the assembly is not too hard with a pin and a soft mallet. (I told you the labor was high).
The head should snap firmly into the lure body and be removable when you are done. Do not clear coat with the head and body assembled :)