1 / 5
Pelican/Peli Storm case wheel bearing spacers for 608ZZ bearing — image 1
1 / 5

Pelican/Peli Storm case wheel bearing spacers for 608ZZ bearing

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a spacer to allow 608ZZ type bearings to be used on large Storm cases which are designed for wider

Rating
0 / 5
Likes
6
Downloads
28
Makes
0
Views
469
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I realised my Peli/Pelicam Storm iM2975 case was hard to pull, and on getting home I spun a wheel - ooops, yes it's trashed! I removed the wheel and saw that the bearing is non-standard, they have little stub-axle type things, one has a wider shell than the other, and they look pretty low quality for such an expensive case. I could get a new set of wheels, but where's the fun in that? :D

I saw that the wheel's inset IS perfect to fit a 608ZZ (skateboard) bearing though - possibly the same wheel is used on the other models with a narrower bearing but the wheel's mounting has to be wider for strength on the larger models?

Anyway, to fit the 608ZZ it needs a spacer each side, otherwise the bearing will slip out and probably ruin both the wheel and case if you don't notice. This model is a spacer/washer just wide enough to work. There is a tiny bit of play still - if you want a tight fit then print it a little thicker (maybe +0.2mm?).

Replacement involves:

  • Put a slotted screwdriver in the loop of the axle's circlip and tap sharply with a hammer to remove
  • Push/pull out the axle - this should be pretty easy
  • Pull the wheel out. If your bearings are trashed like mine you may need to use violence.
  • Remove the old bearing. You'll need to rest the wheel with something each side of the bearing and then drift it out from the other side using an old screwdriver or similar. They are only pressed in quite lightly.
  • Clean the grime out of the inset
  • Put a 608 bearing in. They pushed in all mine easily except one which needed tapping with a hammer
  • Put the axle back partly into the case and slip one of the spacers on the end
  • Insert the wheel and push the axle through until it just pokes out the other side
  • Use the included tool to hold and insert the second spacer into the gap. Look through the hole to line it up while pushing the axle through fully
  • Put the circlip back on. This can be tricky - a screwdriver and sharp tap with a hammer can work. Do wiggle and twist the axle to check that it's on properly, otherwise it might fall off later at an extremely inconvenient time!

According to a parts list for a replacement wheel, this should work for the: iM2435, iM2720, iM2750, iM2875, iM2950, iM2975, iM3075, iM3100, iM3200, iM3300, iM3410