D2F Microswitch Endstop Soldering Jig
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
D2F Variants Soldering Jig for use with 24-22 AWG
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 195
- Makes
- 4
- Views
- 879
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
For use with 24-22 AWG wire. Hard to solder while holding the the soldering iron, legs, and wires at the same time so I created this jig to hold at least the D2F-5L but I left the top open so most other variants should be able to fit also except for the solder terminal variants. Left picture is PLA and right is ASA. You should probably use ABS or ASA but if you don't mind then go for PLA.
The small base I put on helps by giving you something to hold everything in place while soldering and not having it slide all over the place.
New revision: Removed the walls near the outside legs to eliminate plastic from being in the way of a soldering iron. But also removed center wiring channel since you only need the outside legs.