Mausoleum Flower Vase
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Flower vase for mausoleum wall/headstone.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 118
- Makes
- 0
- Views
- 1,083
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Share Alike
This is a flower vase that can normally be found on a mausoleum memorial wall or headstone at a cemetery. It is a drop-in vase that fits in an 80mm ring that is mounted to the wall/headstone. It was created as a less expensive option than buying a new vase from the cemetery office (who are quite proud of their plastic vases). This is a useful replacement in case of theft or damage to your existing vase.
Overall dimensions are ~200mm tall and 125mm at the widest part of the mouth, with a step/taper for ~ 132mm of the long body of the vase. Each of the steps is ~ 12.5mm in height. Wall thickness is ~ 2mm to give strength and printed w/4 perimeters. Model was created using Fusion 360.
For best looking print, print with vase upside down and add supports to the inside of the vase. Those snap off post-printing, but clean-up isn't required since the rough areas are “inside” the vase and will be covered w/flowers and water. Vase in photo was printed using HATCHBOX “Bronze” PETG 1.75mm filament.