AT-5555N II Handles
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Handles for the AT-5555N2 all mode 10m radio. They can provide a measure of protection for the front panel.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 48
- Makes
- 0
- Views
- 222
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is a set of handles for use with an Anytone AT-5555N II 10m all mode radio. They can provide some assistance in handling an unmounted radio, provide a measure of protection for the front panel & knobs, and raise the radio above a flat surface to improve audibility of the bottom mounted speaker and enhance air flow for cooling. There is also a provision for “prop” sticks to raise the radio front for better display visibility and sound direction.
No need for supports. I printed using ASA for environmental durability. This print requires a print bed of at least 300mm to print in one piece. It could be segmented for printing on a smaller printer, but such a modification is not included.
With my settings, 0.3mm layers with a 0.6mm nozzle, print time was about 3 hours and used about 120g of material on my XMax3.
Handles are attached with two M5x10 screws, 4 total.
STEP file & Fusion 360 source included