Fan Shroud / Duct Upgrade Prusa XL
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Better fanshroud for Prusa XL that actally directs the air towards the nozzle from three directions.
- Rating
- 4.667 / 5
- Likes
- 233
- Downloads
- 1,081
- Makes
- 23
- Views
- 6,652
- Reviews
- 21
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v2.0
Introduction:
We all know how the original partcooling on the Prusa XL just blasts air from left to right totally uncontrolled. There have been a couple of attemts to fix this, but I wasn't able to find a fanshroud that satisfied me. So I took inspiration of my favourite fanshroud for the mk4 and the closest part to what I wanted and combined the two ideas.
On the latest iteration, the fan selftest was sucessful, so there isn't to much backpressure, a problem several prototypes had.
I took a picture of the water test, but it's almost impossible to see what's going on if you don't have it in front of you.
Update: I tested this model for quite a couple of printing hours now. If you are printing PLA, fanshrouds made out of ASA or something similar are holding up fine. If you are printing materials with higher nozzle temperatures, I'd recommend printing the fan shroud in something more temperature resistant like PA-CF.
Update: V3.4 is here with the following improvements:
- I tilted the shroud by 1 degree, so it is parallel to the printbed
- I included a support structure for the edges at the exit
- I made some progress in terms of clearence to the printbed as well as the hotend
There are a total of four different variations for you to choose from, each one with or without supports:
- best performing without increased clearences
- Increased bed clearence (ibc) with 0.5 mm more vertical space
- Increased hotend clearence (ihc) with approximatly 1mm more space between the shroud and the hotend
- Combination of the increased clearence modifications (ihc & ibc) to minimize the risk of a meltdown
All of those can be printed without supports. There is an internal feature to help with bridging, but make sure you have your filament settings dialed in. I achieved the best results with Polymakers PA6-CF at 280°C, 50mm/s and 30% cooling fan for bridging on the mk4. Obviously with @Ian_prints MK4 print fan shroud upgrade.
Disclaimer: I have not tested all of these variations extensively, let me know if you run into some issues with one of them.
If you have noticed any areas where some rework would be welcome, make sure to let me know!
IMPORTANT: If you've printed this shroud and got some valuable observations after using it for some time, please share them. I want to constantly improve the design. That's only possible with tests, but when it comes to testing, I am somewhat limited by the fact that I only have one Prusa XL. So every contribution by the community is helping the iterative design process.
DISCLAIMER: At the moment, there is an open investigation about the performance of the fan duct. I only had positive experience with it, and so did a couple of other people. But recently, @IPIND3D tested it and it did pretty bad, so until I found the cause of this, print at your own risk I guess ;-)