PS5 controller holder for IKEA pegboard

How to use

• print left and right holders and 2 hooks
• glue hooks into the notch at the back of the holders
• attach to the peg board 3 slot away (see photos)

Features

• seamless fit (because it is derived from a 3D scan)
• print without support
• simple shape makes it print in about 1h
• good strength ensured by separating hooks and holders

Optimal printing orientation is shown below:

I also made one for the PS4 DualShock controller

https://www.printables.com/model/1241127-ps4-controller-holder-for-ikea-pegboard

How I designed it

I saw many PS5 controller holders for IKEA pegboard but none of them fit the controller perfectly. When I tap the holder, the controller on it also shakes where I see space for improvement.

Recently, I see an 3D scan of the PS5 controller uploaded by another user. I try to simplify its shape and re-model it using a CAD software but soon found it is quite difficult. I cannot copy the shape using the sketch and extrude workflow. It would be better if I can modify from the scan.

I go learned blender and here is the general steps of how I created the model

• perform re-topology to make the mesh easier to work with
• apply solidify modifier to the surface to the desired wall thickness
• add a flat surface to allow it adhere to the print surface without support
• add a hole for attach the hook using a regular CAD software (boolean subtract)

https://cad.onshape.com/documents/cb7f7f0751ad71cd18c32cde/w/348b6835b36fff87d2a7ca23/e/9d410d103a68fbdf6ff9b124?renderMode=0&uiState=65fe9800d2ba1a22b8299c26

Hope you like it~

About remix and the license

I'm not sure if I should mark this as a remix, if not I would choose to use a more permissive license (CC-BY). Let me know how you would grant the permission