1 / 5
Vase mode phone stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this is a phone stand printed in vase mode in under 30 minutes
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 48
- Makes
- 0
- Views
- 366
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This little phone stand is printed in only 15 minutes and designed to use mega thick layer hights like 0.5 or 1mm for vase mode. If you are planning on using it for a giant and heavy phone about 1.5-2mm estrusion width is recommended but for any other phones 1 mm is just fine.