Dialed in Pinball Bob sign(s)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made these enclosures for the Dialed In JJP Pinball machine "Bob" signs as the original sign brackets were eh....
- Rating
- 5 / 5
- Likes
- 1
- Downloads
- 29
- Makes
- 1
- Views
- 208
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an enclosure for the Dialed In JJP pinball machine “Bob” signs as the originals were not backlit. You will need to make or purchase the .093 molex connector power connector kit from Mezel mods. https://mezelmods.com/products/12v-fused-power-tap-jjp-system?_pos=30&_sid=b49da000d&_ss=r and the appropriate 12v led strip. These are just plain led light strip with no need for rgb controls. This was a take off of the Mezel mod light, but theirs was open in the rear and throws a lot of backscatter light on the side wall. I printed these at standard setting with a .2 layer height on their base with organic supports. The smaller sign slides under the ramp support, not the flasher.