1 / 11
iPhone 15 plus bumper case (minimalistic)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Protects your phone and especially the camera bulge in the back against scratches and bumps while allowing the phone…
- Rating
- 4 / 5
- Likes
- 23
- Downloads
- 380
- Makes
- 2
- Views
- 1,768
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Protects your phone and especially the camera bulge in the back against scratches and bumps while allowing the phone to cool properly when charging or in use.
Update 4-10-24: added speaker notch; keeping only the camera bulge ring design going forward.
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
0.2 mm
Infill:
10%
Filament: any TPU any
Notes:
- Print in TPU in the orientation shown in the screenshot.
- Raise bottom contact distance to 0.4 or deactivate the bottom interface layers to make supports easier to remove.
- Choose classical supports placed everywhere.
- Pick two top support interface layers with a separation of 0.2 mm and rectilinear pattern.
- I chose a bridging pattern angle of 60º and 70% infill/perimeter overlap to get successful bridging atop the supported areas.
- In Prusa Slicer 2.7.3+ make sure you enable the "detect bridging perimeters" section--but not in earlier versions where a bug causes perimeters to be printed outside supports.
Category: Mobile Phone